Teak Chair With Rattan

The Teak Chair with Rattan is a dining-height seating unit constructed from solid plantation-grown teak wood combined with natural woven rattan. The overall dimensions measure 42.00 centimeters in width, 53.00 centimeters in depth, and 88.00 centimeters in total height. The physical weight of the individual chair is 7.20 kilograms, while the packed volume occupies 0.1500 cubic meters for shipping calculations.

The primary structural frame utilizes solid teak timber, visible across the legs, seat apron, and backrest supports. Teak wood contains natural high oil and rubber content, which contributes directly to its resistance against moisture, fungal decay, and insect damage. The grain pattern features a tight, straight alignment with a golden-brown coloration that gradually develops a silver-gray patina when exposed to ultraviolet light over extended periods. Each wooden component undergoes kiln-drying to reduce moisture content, minimizing subsequent warping or splitting under standard indoor climate conditions.

The backrest incorporates a rectangular frame inset with a woven rattan panel. The rattan material consists of peeled and processed stems of climbing palms native to tropical regions. This woven section utilizes a traditional cane mesh technique, creating an open hexagonal pattern that allows air circulation through the back support. The flexibility of the woven rattan provides a degree of give when pressure is applied against the backrest, adapting slightly to the user’s spine. The perimeter of the rattan insert is secured into a routed groove within the teak frame and finished with a thin rattan binder cane to conceal the fastening points.

The seat platform consists of a solid teak wooden board shaped with a subtle ergonomic depression to distribute weight evenly across the surface. The edges of the seat are rounded to prevent sharp contact points against the back of the thighs. Four legs connect to the seat frame using mortise and tenon joinery, a traditional woodworking method that relies on interlocking wooden components rather than metal fasteners alone. The front legs extend straight downward from the corners, while the rear legs angle slightly outward to increase the physical footprint and stability of the chair. H-stretchers connect the four legs approximately midway down their length, providing lateral bracing that absorbs weight loads and prevents the frame from racking under frequent movement.

Measuring 42.00 centimeters wide at the front edge, the seat tapers slightly toward the back junction to match the structural geometry of the frame. The total depth of 53.00 centimeters accounts for the backward slant of the backrest relative to the front legs. The seating surface sits at a standard height from the floor, pairing functionally with dining tables measuring between 75 and 80 centimeters high. The top of the backrest reaches 88.00 centimeters, providing shoulder-level support for an average adult user.

At 7.20 kilograms per unit, the mass of the chair is sufficient to remain stable during normal pull-out and push-in usage at a dining table, yet light enough for one-handed lifting and repositioning. The spatial displacement of 0.1500 CBM per chair determines container loading capacities for bulk transport, allowing multiple units to be nested or stacked depending on the specific crating configuration used by the manufacturer.

Maintenance requirements for the Teak Chair with Rattan involve standard care procedures for wood and natural fibers. The teak surfaces can be cleaned using a damp cloth with mild soap, avoiding harsh chemical solvents that strip the natural oils. The rattan backrest requires periodic dusting using a soft brush attachment on a vacuum or a dry cloth to prevent particulate accumulation within the woven interstices. Direct exposure to continuous moisture or extreme temperature fluctuations should be avoided to preserve the structural integrity of the rattan bindings and the wooden joinery over years of daily service.