Chair Eko Bentwood

The CHAIR EKO BENTWOOD is a standalone dining and seating unit constructed primarily from solid teak wood. The frame utilizes bentwood manufacturing techniques, a process involving the application of moisture and heat to pliable timber strips, which are then secured into curved configurations using mechanical molds. This method exploits the natural grain structure of teak, resulting in a continuous structural curve that forms both the rear support and the upper backrest of the chair.

Measuring 46.00 centimeters in width, the seat spans a standard proportional footprint suitable for dining tables, desk setups, and conference environments. The total depth of the unit is 56.00 centimeters, providing adequate clearance from the front edge of the seat to the vertical plane of the backrest. The overall height reaches 84.00 centimeters from the floor to the topmost point of the curved teak crest rail. The seat pan is positioned at standard dining height, allowing users to sit upright with feet resting flat on the floor, accommodating a broad range of human body proportions.

The primary material, teak, is a dense tropical hardwood known for its natural oil content and high tensile strength. This inherent composition resists moisture absorption, fungal decay, and warping under fluctuating indoor humidity levels. The visible surfaces display a natural wood grain pattern, finished with a clear protective coat that seals the pores of the timber while retaining the raw visual texture of the teak. The joinery combines traditional mortise and tenon joints with modern structural adhesives, distributing weight loads evenly across the four legs and preventing lateral wobble during use.

Weighing 5.50 kilograms, the chair is lightweight enough for single-person relocation, stacking, or repositioning around a table without mechanical assistance. Despite the low weight, the structural density of the teak frame prevents tipping under standard horizontal and vertical load tests. The four legs taper slightly downward from the seat frame, terminating in flat contact points designed to distribute weight evenly across hard flooring surfaces as well as low-pile carpets.

The volumetric displacement of the unit measures 0.2100 cubic meters per piece, a specific metric relevant for freight calculation, shipping container consolidation, and spatial storage planning. The chair ships fully assembled in most configurations, eliminating the requirement for manual fastener tightening or wrench assembly upon delivery.

The backrest consists of a single wide piece of bent teak, curved ergonomically to follow the lumbar and thoracic contour of the human spine. The curvature supports the lower back while maintaining an upright posture orientation suitable for dining or focused work tasks. The seat surface is flat with softly rounded perimeter edges to prevent sharp pressure points against the back of the thighs.

Maintenance requirements for the CHAIR EKO BENTWOOD involve routine dusting with a dry microfiber cloth and occasional treatment with natural wood oils to maintain the moisture barrier of the teak surface. Direct exposure to prolonged, unfiltered sunlight or standing water should be avoided to prevent localized fading or grain lifting. The hardware-free aesthetic of the primary bentwood components ensures that structural stress points remain reinforced by the continuous grain of the wood rather than metal screws or bolts, which can loosen over extended cycles of daily use.